Loading Paper In The Tray 5 (Bypass) - Fuji Xerox ApeosPort-III C2201 Administrator's Manual

2 Paper and Other Media
1
Pull out the tray towards you until it stops.
Important • While the machine processes a job, do
2
Load and align the edge of the paper against
the left edge of the tray with the side to be
copied or printed on facing up.
Important • Do not load paper exceeding the
2
3
Push the tray in gently until it comes to a stop.
Important • When inserting the tray, push it gently. When the tray is being pushed with force, it may

Loading Paper in the Tray 5 (Bypass)

When printing or copying with paper sizes or types that cannot be set in the Trays 1 to
4, use the Tray 5 (Bypass). The following describes how to load paper into the Tray 5
(Bypass).
To make detailed instructions for printings, specify the instructions using the [Tray/
Output] tab in the print driver. When doing this, also specify the type of paper to load.
Important • Do not supply new paper until the tray runs out of paper, in order to prevent paper jams and
Note
1
Open the Tray 5 (bypass).
Note
40
not pull the tray out that the job uses.
• Do not add a new stack of paper on top of
the remaining paper in the tray to prevent
paper jams or making mistakes of paper
loading. Remove the remaining paper in
the tray, put it on top of the new stack of
paper, and then load the stack of paper in
the tray.
maximum fill line. It might cause paper
jams or machine malfunctions.
• Do not place any paper or objects in the
empty space on the right side of the Tray
1 to 4. It may cause paper jams or
machine malfunctions.
cause machine malfunctions.
not to have the machine misidentify the amount of paper loaded in the tray.
• Before loading paper in a tray, fan the paper well. It prevents paper from sticking to each
other and reduces paper jams.
• If necessary, extend the extension flap.
The extension flap can be extended in
two stages. When pulling out the
extension flap, do it gently.