Fuji Xerox ApeosPort-III C2201 Administrator's Manual page 450

14 Problem Solving
Error Code
C P F S M O
035-720
035-721
035-722
035-723
035-724
035-725
035-726
035-727
035-728
035-729
035-730
035-731
035-732
035-733
035-734
035-735
035-736
035-737
035-738
035-739
035-740
035-741
14
035-742
035-743
035-744
035-745
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
448
Category
O [Cause]
[Remedy] For error during fax transmission: Check if the fax number
O [Cause]
[Remedy] Ask the sender to try again.
O [Cause]
[Remedy] For sending error, check the destination phone number,
O [Cause] Unable to communicate because the fax number is
[Remedy]Check if the fax number is correct and the destination
O [Cause]
[Remedy] For sending error, check the destination phone number,
O [Cause]
[Remedy] Ask the sender to try again.
O [Cause]
[Remedy] For sending error, check the destination phone number,
O [Cause]
[Remedy] Check the destination phone number, check also if the
Cause and Remedy
An communication error occurred.
is correct and if the destination machine has the specified
feature, and then try again.
For error during fax reception: Ask the sender to try again.
Communication error
Communication error
check also if the destination machine has the feature you
specified, and then try again.
For receiving error, ask the sender to try again.
incorrect or the destination machine does not have the
specified feature.
machine has the specified feature, and then try again.
Communication error
check also if the destination machine has the feature you
specified, and then try again.
For receiving error, ask the sender to try again.
Communication error
Communication error
check also if the destination machine has the feature you
specified, and then try again.
For receiving error, ask the sender to try again.
Unable to communicate. The phone number is incorrect or
the destination machine does not have the feature you
specified.
destination machine has the feature you specified, and
then try again.