Ip Address - Manual Configuration; Configuration - Unify OpenStage 60 Administration Manual

administration.fm
Administration
IP Network Parameters
3.3.4

IP Address - Manual Configuration

3.3.4.1

Configuration

If not provided by DHCP dynamically, the phone's IP address and subnet mask must be
specified manually.
IP addresses can be entered in the following formats:
>
– Decimal format. Example: 11.22.33.44 or 255.255.255.0 (no leading ze-
roes).
– Octal format. Example: 011.022.033.044 (leading zeroes must be used with
every address block)
– Hexadecimal format. Example: 0x11.0x22.0x33.0x44 (prefix 0x must be
used with every address block)
By default, IP configuration by DHCP and LLDP-MED is enabled. For manual IP configuration,
please proceed as follows:
1. Navigate to Network > General IP configuration. Set DHCP Enabled, DHCPv6 Enabled
and LLDP-MED to "not selected". Afterwards, click Submit.
2. Navigate to Network > General IP configuration> IPv4 configuration or IPv6 configu-
ration depending on settings in Section 3.3.2, "Protocol Mode IPv4/IPv6". Enter the IP ad-
dress and the Subnet mask. If applicable, enter the Default route. Afterwards, click Sub-
mit.
IPv4 configuration
LLDP-MED Enabled
DHCP Enabled
DHCP lease reuse
IP address 192.168.1.235
255.255.255.0
Subnet mask
192.168.1.2
Default route
Route 1 IP address
Route 1 gateway
Route 1 mask
Route 2 IP address
Route 2 gateway
Route 2 mask
Reset
Submit
3. After the phone's network service has restarted, the other IP parameters can be
configured.
68
Global Address Prefix Len
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
IPv6 configuration
LLDP-MED Enabled
DHCPv6 Enabled
DHCPv6 lease reuse
Global Address
Global Gateway
Link Local Address
Route 1 Dest.
Route 1 Prefix Len
Route 1 Gateway
Route 2 Dest.
Route 2 Prefix Len
Route 2 Gateway
Submit Reset
A31003-S2030-M100-11-76A9, 01/2015