Hot/Warm Phone - Unify OpenStage 60 Administration Manual

administration.fm
Administration
Feature Configuration
3.7.2

Hot/Warm Phone

If the phone is configured as hot phone, the number specified in Hot warm destination is di-
aled immediately when the user goes off-hook. For this purpose, Hot warm phone must be set
to "Hot phone". If set to "Warm phone", the specified destination number is dialed after a delay
which is defined in Initial digit timer (seconds) (for details, see Section 3.7.3, "Initial Digit Tim-
er"). During the delay period, the user can dial a number which will be used instead of the hot/
warm destination. In addition, the user will be provided with a dial tone during the delay period.
With the setting "No action", hot phone or warm phone functionality is disabled.
Administration via WBM
System > Features > Configuration
Configuration
General
Emergency number
Voice Mail number
MWI LED
Missed call LED
Allow refuse
Hot/warm phone
Hot/warm destination
Initial digit timer (seconds)
Allow uaCSTA
Server features
Not used timeout (minutes)
Transfer on hangup
Bridging enabled
Dial plan enabled
FPK program timer
Audio
Group pickup tone allowed
Group pickup as ringer
Group pickup visual alert
BLF alerting
MLPP ringer
Callback ringer
Impact level ringer
Bluetooth
Enable Bluetooth interface
Call Recording
Recorder Address
Recording Mode
Audible Notification
Submit
128
3335
Key & AlertBar
Key only
;
No action
30
;
5
;
;
On
;
;
Prompt
Beep
alert-internal
;
Disabled
Off
Reset
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
A31003-S2030-M100-11-76A9, 01/2015