Automatic Vlan Discovery Using Dhcp - Unify OpenStage 60 Administration Manual

3.2.2.2

Automatic VLAN discovery using DHCP

To automatically discover a VLAN ID using DHCP, the phone must be configured as DHCP en-
abled, and VLAN discovery mode must be set to "DHCP". LLDP-MED should be disabled.
The DHCP server must be configured to supply the Vendor Unique Option in the correct VLAN
over DHCP format. If a phone configured for VLAN discovery by DHCP fails to discover its
VLAN, it will proceed to configure itself from the DHCP within the non-tagged LAN. Under these
circumstances, network routing may probably not be correct.
Administration via WBM
Network > General IP configuration
To enable VLAN discovery via DHCP, activate the DHCPv6 Enabled checkbox and select
DHCP in the VLAN discovery option. Afterwards, click Submit.
General IP configuration
Protocol Mode IPv4_IPv6
LLDP-MED Enabled
DHCP Enabled
DHCPv6 Enabled
VLAN discovery DHCP
VLAN ID
DNS domain
Primary DNS
192.168.1.105
Secondary DNS
192.168.1.2
HTTP proxy
Submit Reset
Administration via Local Phone
To enable VLAN discovery via DHCP, activate the DHCPv6 Enabled checkbox and select
DHCP in the VLAN discovery option.
|
--- Admin
|
--- Network
|
--- General IP configuration
|
--- Protocol mode
|
--- Use LLDP-MED
|
--- Use DHCP
|
--- Use DHCPv6
|
--- VLAN discovery
|
--- VLAN ID
A31003-S2030-M100-11-76A9, 01/2015
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
;
administration.fm
Administration
LAN Settings
57