Ip Network Parameters; Quality Of Service (Qos); Layer 2 / 802.1P - Unify OpenStage 60 Administration Manual

administration.fm
Administration

IP Network Parameters

3.3 IP Network Parameters
3.3.1

Quality of Service (QoS)

The QoS technology based on layer 2 and the two QoS technologies Diffserv and TOS/IP Pre-
cedence based on layer 3 are allowing the VoIP application to request and receive predictable
service levels in terms of data throughput capacity (bandwidth), latency variations (jitter), and
delay.
Layer 2 and 3 QoS for voice transmission can be set via LLDP-MED (see Section
>
3.26.6, "LLDP-MED"). If so, the value can not be changed by any other interface.
3.3.1.1

Layer 2 / 802.1p

QoS on layer 2 is using 3 Bits in the 802.1q/p 4-Byte VLAN tag which has to be added in the
Ethernet header.
The CoS (class of service) value can be set from 0 to 7. 7 is describing the highest priority and
is reserved for network management. 5 is used for voice (RTP-streams) by default. 3 is used
for signaling by default.
Data required
• Layer 2: Activates or deactivates QoS on layer 2.
Value range: "Yes", "No"
Default: "Yes"
• Layer 2 voice: Sets the CoS (Class of Service) value for voice data (RTP streams).
Value range: 0-7
Default: 5
Layer 2 signalling: Sets the CoS (Class of Service) value for signaling.
•
Value range: 0-7
Default: 3
Layer 2 video: Sets the CoS (Class of Service) value for video.
•
Value range: 0-7
Default: 4
Layer 2 default: Sets the default CoS (Class of Service) value.
•
Value range: 0-7
Default: 0
60
PREAM. SFD DA SA
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
Three Bits Used for CoS
(User Priority)
TAG
PT DATA
4 Bytes
A31003-S2030-M100-11-76A9, 01/2015
FCS