Settings For A Dss Key - Unify OpenStage 60 Administration Manual

Administration via WBM
System > Features > DSS Settings
DSS settings
Call pickup detect timer (seconds)
Deflect alerting call enabled
Allow pickup to be refused
Forwarding shown
Submit
Administration via Local Phone
|
--- Admin
|
--- System
|
--- Features
|
--- DSS operation
|--- Deflect to DSS
|--- Refuse DSS pickup
|
--- Forwarding shown
|
--- Admin
|
--- System
|
--- Features
|
--- Configuration
|
--- General
3.11.5.2

Settings for a DSS key

The Key label <n> parameter provides the DSS key with a label that is displayed on the graph-
ic display on an OpenStage 40/60/80 phone. The label is also user configurable.
Address contains the call number of the line associated with the DSS key.
The Realm parameter stores the SIP Realm of the line associated with the DSS key.
User Identifier gives the SIP user ID of the line associated with the DSS key.
Password provides the password corresponding to the SIP user ID.
The Outgoing calls parameter determines the behaviour of a call over the DSS line at the tar-
get phone. If set to "Direct", any forwarding and Do not Disturb settings on the target phone will
be overridden, so that a call will always alert. If set to Line type is set to "Normal", this is not the
case, and the call will be treated like a regular call.
A31003-S2030-M100-11-76A9, 01/2015
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
3
Reset
|
--- DSS Pickup timer
administration.fm
Administration
Multiline Appearance/Keyset
187