Use Dhcp - Unify OpenStage 60 Administration Manual

3.3.3

Use DHCP

If this parameter is set to "Yes" (default), the phone will search for a DHCP server on startup
and try to obtain IP data and further configuration parameters from that central server.
If no DHCP server is available in the IP network, please deactivate this option. In this case, the
IP address, subnet mask and default gateway/route must be defined manually.
The phone is able to maintain its IP connection even in case of DHCP server failure.
>
For further information, please refer to Section 2.3.4, "DHCP Resilience".
The following parameters can be obtained by DHCP:
Basic Configuration
• IP Address
• Subnet Mask
Optional Configuration
• Default Route (Routers option 3)
• IP Routing/Route 1 & 2 (Static Routes option 33, Classless static route option 121, Private/
Classless Static Route (Microsoft) option 249)
• SNTP IP Address (NTP Server option 42)
• Timezone offset (Time Server Offset option 2)
• Primary/Secondary DNS (DNS Server option 6)
• DNS Domain Name (DNS Domain option 15)
• SIP Addresses / SIP Server & Registrar (SIP Server option 120)
• VLAN ID, DLS address (Vendor specific Information option 43)
The following parameters can be obtained by DHCPv6:
Basic Configuration
• Global Address
• Global Address Prefix Length
Optional Configuration
• Primary/Secondary DNS (DNS recursive name server option 23)
• SNTP IP Address (Simple Network Time Protocol Server option 31)
A31003-S2030-M100-11-76A9, 01/2015
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
administration.fm
Administration
IP Network Parameters
65