Remote Tracing - Syslog - Unify OpenStage 60 Administration Manual

3.26.14 Remote Tracing – Syslog
All trace messages created by the components of the phone software can be sent to a remote
server using the syslog protocol. This is helpful especially for long-term observations with a
greater number of phones.
To enable remote tracing, Remote trace status must be set to "Enabled". Furthermore, the IP
address of the server receiving the syslog messages must be entered in Remote ip, and the
corresponding server port must be given in Remote port.
With version V2, the User notification parameter controls whether the user is notified about
the remote tracing or not. If user notification is enabled, a blinking symbol (
60/80; on OpenStage 15/20/40) will inform the user when remote tracing is active, that is,
when Remote trace status is set to "Enabled".
Administration via Local Phone
|
--- Admin
|
--- Maintenance
|
--- Remote trace
|--- Remote trace status
|--- User notification
|--- Remote ip
|
--- Remote port
Administration via WBM
Remote trace
Remote Trace Status Disabled
Enabled
Use Notification
Remote Server
Remote Server Port 514
Submit
A31003-S2030-M100-11-76A9, 01/2015
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
Reset
administration.fm
Administration
Diagnostics
on OpenStage
301