Manual Configuration Of A Vlan Id - Unify OpenStage 60 Administration Manual

administration.fm
Administration
LAN Settings
3.2.2.3

Manual configuration of a VLAN ID

To configure layer 2 VLAN manually, make sure that VLAN discovery is set to "Manual" and
LLDP-MED is disabled. Then, the phone must be provided with a VLAN ID between 1 and
4095. If you mis-configure a phone to an incorrect VLAN, the phone will possibly not connect
to the network. In DHCP mode it will behave as though the DHCP server cannot be found, in
fixed IP mode no server connections will be possible.
Administration via WBM
Network > General IP configuration
The phone must be provided with a VLAN ID between 1 and 4095. Set the VLAN discovery to
"Manual". Afterwards, click Submit.
General IP configuration
Protocol Mode IPv4_IPv6
LLDP-MED Enabled
DHCP Enabled
DHCPv6 Enabled
Manual
VLAN discovery
VLAN ID
DNS domain
Primary DNS
192.168.1.105
Secondary DNS
192.168.1.2
HTTP proxy
Submit Reset
Administration via Local Phone
|
--- Admin
|
--- Network
|
--- General IP Configuration
|
--- VLAN ID
To enable VLAN discovery by Manual, select Manual in the VLAN discovery option.
|
--- Admin
|
--- Network
|
--- General IP configuration
|
--- VLAN discovery
58
;
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
A31003-S2030-M100-11-76A9, 01/2015