Authentication Unit (IC Card Type AU-201)
–
When the machine is turned off, then on again with the main power switch, wait at least 10 seconds
to turn the machine on after turning it off. The machine may not operate correctly if it is turned on
immediately after being turned off.
–
Hold the plug when plugging and unplugging the USB cable, otherwise the cable may be damaged.
2
Turn on the machine with the main power switch.
3
Connect the authentication unit to the USB port of the computer installed with Data Administrator.
–
Do not connect other USB devices to the same port where the authentication unit is connected. If
enough USB power is not provided, Authentication Unit (IC Card Type) may not operate correctly.
–
When using a USB hub, be sure to use a self-powered USB hub that can provide 500 mA or more.
–
After connecting the authentication unit, wait at least 5 seconds before operating it.
–
If the data have already been read out, proceed to 7.
4
Find this device in the window, then double-click it.
5
Click [Import].
VarioLink 6022/7522
13
13-11