Utility mode
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [5 Punch Horizontal Position Adjustment].
The Punch Horizontal Position Adjustment screen appears.
6
Check the horizontal position of the punched holes.
–
To increase width A, touch [+] to increase the adjustment (between 0.1 mm and 5.0 mm).
–
Each time [+] or [-] is touched, the value is increased or decreased by one increment.
–
To decrease width A, touch [-] to decrease the adjustment (between -0.1 mm and -5.0 mm).
7
Touch [OK].
–
To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completes
the procedure.
VarioLink 6022/7522
A
A
11
11-46