Table of Contents
Advertisement
Application functions
7
Select the desired copy settings, and then press the [Start] key.
–
To print a single copy to be checked, press the [Proof Copy] key.
–
Repeat steps 5 to 7 until all originals have been scanned. The amount of memory available can be
checked beside "Memory" in the lower-left corner of the screen. In addition, the number of original
batches can be checked beside "Scanned Batches".
–
When the memory is full, a message appears. Select whether to delete the last part of the data and
scan it again, delete the last part of the data and print, or delete all of the original data.
–
To cancel changes to the settings, touch [Cancel].
Scanning begins. After scanning is finished, touch [Fix], and then touch [OK].
Is there more information about the settings?
?
% Refer to the appropriate section.
8
After all original pages have been scanned, touch [Finish].
A message appears, requesting confirmation that scanning is finished.
9
Touch [Yes], and then touch [OK].
–
If "No" was selected, touch [Change Setting] to change the copy settings.
VarioLink 6022/7522
7
7-20
Advertisement
Table of Contents
Troubleshooting
