Table of Contents
Advertisement
Authentication Unit (Biometric Type AU-101)
2
Click the [Plug-in version] button.
3
From the "Plug-in information list", check the version of the Data Administrator plug-in.
–
If the plug-in version appears as "4.x": This software can be used.
Setup
1
Turn off the machine with the main power switch, and then disconnect the authentication unit from the
machine.
2
Install BioDriver (USB-Driver).
–
Plug the cable from the authentication unit into the USB port on the computer.
–
The Found New Hardware Wizard starts.
3
Select "Yes, now and every time I connect a device", and then click [Next].
4
Insert the application CD-ROM included with the authentication unit into the CD-ROM drive of the
computer.
VarioLink 6022/7522
12
12-7
Advertisement
Table of Contents
Troubleshooting
