Panel Unit - Epson WorkForce 600 Service Manual

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW

4.3.5 Panel Unit

Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover
Removal procedure
1. Pull out the Panel Unit in the direction of the arrow (1) while pulling the Panel
Lever.
2. Push the Panel Shafts into the Panel Unit
(2) with a flathead screwdriver etc. and remove the Panel Shafts (x2) from the
grooves (x2) of the Upper Housing.
Back side
Panel Shaft
Groove
2
1
Figure 4-16. Removing the Panel Unit (1)
DISASSEMBLY/ASSEMBLY
(x2) in the direction of the arrow
Upper Housing
Panel Unit
Removing the Housing
3. Remove the ferrite core from the Pressing plate of the Upper Housing in the
direction of the arrow (1), and peel off the Panel FFC from the Upper
Housing.
4. Remove the grounding wire from the grooves (x8) of the Upper Housing.
5. Slide the Panel Unit in the direction of the arrow (2) while pulling the Panel
Lever, and remove the Panel Unit from the Upper Housing.
Panel Lock
Panel FFC
Fold
Pressing Plate
Grounding wire
2
Figure 4-17. Removing the Panel Unit (2)
Revision A
Ferrite core
Pull out the Panel FFC
from the hole of the
Upper Housing.
1
Double-sided tape
Groove
Panel Unit
100
Confidential