Panel Unit - Epson Stylus C110 Service Manual

EPSON Stylus C110/C120/D120

4.4.2 Panel Unit

Part/Unit that should be removed before removing Panel Unit
Upper Housing
Removal Procedure
1. Peel off the Panel Unit FFC that is secured with the double-sided tape (x1) from
the Panel Unit, and disconnect the FFC (x1) from the connector of the Panel Unit.
2. Release the rib (x1) of the Panel Unit from the cutout (x1) of the Front Frame, and
remove the Panel Unit.
Marking-off Line
Rib and Cutout
Figure 4-18. Removing Panel Unit
DISASSEMBLY/ASSEMBLY
Panel Unit
Connector of the
Panel Unit FFC
Tape position
3. Remove the screws (x2) that secure the Panel Board and the Panel Shield Plate,
and remove them together.
Removing Board
Panel Shield Plate
C.B.S. 3x6, F/Zn-3C (4±0.5kgfcm)
Guide Pin and Positioning Hole
Figure 4-19. Removing Panel Board
Revision B
79