Epson WorkForce 600 Service Manual page 106

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
4.4.3.3 Button/ Power Lens/ Mall Panel
1. Remove the Panel Board and Panel Board B.
(Refer to "4.4.3.1 Panel Board/ Panel Board B
2. Remove the Buttons (x30) shown below from the Panel Cover by releasing
the hooks.
Button
No.
1 Power button
2 Display/Crop button
3 Minus Button, Plus Button
4 Ten keys
5 Auto Answer/Space button
6 Speed Dial/Group Dial/Back Space button
7 Stop/Clear Settings button
3. Remove the screw and remove the Power Lens.
4. Remove the Mall Panel from the Panel Cover.
1 2
14 13 12
Back side
Figure 4-36. Removing the Button/ Power Lens/ Mall Panel
DISASSEMBLY/ASSEMBLY
(p105)")
Button
No.
8 Start button
9 Redial/Pause button
10 Back button
11 Cross Key and OK button
12 Menu button
13 Auto Correct button
14 Top menu button
3 4 5 6 7
11 10 9 8
Mall Panel Power Lens
C.B.P. 2x6, F/Zn-3C (6±1kgfcm)
Removing the Circuit Boards
When installing the Buttons, engage the hook of each Button
securely to the Panel Cover. After assembling the Panel Unit, press
all the Buttons and confirm they click.
4.4.3.4 Panel Shaft
1. Remove the Panel Lower Housing.
(Refer to "4.4.3.1 Panel Board/ Panel Board B
2. Release the ribs (x2) of the Panel Shafts (x2) from the grooves (x2) of the
Panel Lower Housing and remove the Panel Shafts (x2) and Panel Shaft
Springs (x2) from the Panel Lower Housing.
Panel Shaft, Panel Shaft Spring
Panel Lower Housing
Figure 4-37. Removing the Panel Shaft
Revision A
(p105)")
Panel Shaft Spring
Panel Shaft
Rib
107
Confidential