EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
5.
Remove the screws (x1) that secure the Scanner Unit.
6.
Open the Scanner Unit.
7.
Remove the Scanner Unit and the ADF Unit by pulling them out in the
direction of the arrow while taking care not to hook the cables of the Scanner
Unit and ADF Unit to the Upper Housing.
Rear side
ADF Unit
Scanner Unit
Figure 4-5. Removing the Scanner Unit/ADF Unit (2)
DISASSEMBLY/ASSEMBLY
C.B.P. 3x10, F/Zn-3C (6±1kgfcm)
Removing the Housing
Check the following points when routing the cables of the
Scanner Unit and the ADF Unit.
•
To prevent the cables from getting caught, place the cables
and the ferrite cores (x2) inside the printer and make sure not
to let them out of the line
as shown in the figure below.
Figure 4-6. Routing the cables
•
Fold back the Scanner Carriage FFC at the fold shown below.
Align the ferrite core with the line mark, then secure it to the
•
Left Frame with double-sided tapes (x2).
Scanner Carriage FFC
Ferrite core
Fold
Figure 4-7. Routing the cables Scanner Carriage FFC
Revision A
Ferrite cores
Line mark
96
Confidential