Epson WorkForce 600 Service Manual page 63

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
Occurrence
timing Detailed phenomenon
CR position
• Operation
No photos cannot be recognized and an
error is indicated.
• –
Occurrence
timing Detailed phenomenon
CR position
After both surfaces were printed, the
• Operation
paper was ejected but an error is
• –
displayed.
TROUBLESHOOTING
Table 3-16. Check point for Pre-scanning error (photo) according to each phenomenon
Defective
unit/part name
Photo
Table 3-17. Check point for Double feed error according to each phenomenon
Defective
unit/part name
ASF Unit
Error Indications and Fault Occurrence Causes
Check point
1. Check if the photo is set correctly.
Check point
1. Check if the Extension Spring Retard operates correctly
in the paper loading sequence.
Backside of ASF
Extension Spring Retard
2. Check if the Paper Back Lever operates correctly in the
paper loading sequence.
Extension Spring 6.45
Paper Back Lever
Revision A
Remedy
1. Set the photo correctly.
Remedy
1. Set the Extension Spring Retard between the
Retard Roller Unit and the ASF Frame.
2. Set the Extension Spring 6.45 between the ASF
Frame and the Paper Back Lever.
Confidential
64