Epson WorkForce 600 Service Manual page 66

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
Occurrence
timing Detailed phenomenon
CR position
After turning on the power and the
• Power on
initialization process completes, an error
• –
is indicated on the LCD panel.
• Operation
The document is fed, but the reading
process does not starts, and an error is
• Before ADF PF
indicated.
Roller
TROUBLESHOOTING
Table 3-20. Check point for ADF Paper Jam error according to each phenomenon
Defective
unit/part name
1. Check if the ADF Cover Assy is opened.
ADF Cover Assy
1. Check if the ADF Sensor Cable is connected to CN18 on
ADF PE Sensor
2. Check if the ADF Sensor Cable is damaged.
1. Check if the ADF PE Sensor Lever is deformed or
ADF PE Sensor
Lever
1. Check if the Spur Gear 6.4 is correctly attached to the
ADF PF Roller
Error Indications and Fault Occurrence Causes
Check point
the Main Board.
ADF Sensor Cable
CN18
damaged.
ADF PE Sensor Lever
ADF Frame Assy
ADF PF Roller.
Spur Gear 6.4
ADF PF Roller
Revision A
Remedy
1. Close the ADF Cover Assy.
1. Connect the ADF Sensor Cable to CN18 on the
Main Board.
2. Replace the ADF Frame Assy with a new one.
1. Replace the ADF Frame Assy with a new one.
1. Attach the Spur Gear 6.4 correctly.
Confidential
67