Epson WorkForce 600 Service Manual page 110

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
Do not touch or damage the nozzles or the ink supply needles of the
C A U T I O N
Printhead.
10. Remove the screws (x3) that secure the Printhead, and lift the Printhead with
longnose pliers.
3
Figure 4-48. Removing the Printhead (1)
11. Disconnect the Head FFC from the connectors (x3) of the Printhead, and
remove the Printhead.
Figure 4-49. Removing the Printhead (2)
DISASSEMBLY/ASSEMBLY
1 2
C.B.S. 2.5x8, F/Zn-3C (3±1kgfcm)
Printhead
Head FFC
Disassembling the Printer Mechanism
Tighten the screws in the order given in
Insert the Holder Board Assy vertically into the CR Unit so as
not to put the Holder Board Assy on the rib of the Printhead.
Whenever the Printhead is removed/replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
• Chapter 5 " ADJUSTMENT" (p.150)
Revision A
Figure. 4-48.
111
Confidential