Epson WorkForce 600 Service Manual page 61

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
Occurrence
timing Detailed phenomenon
CR position
The LD Roller is not set to the ASF home
• Operation
position and paper is always loaded from
the ASF Unit during the paper loading
• –
sequence.
Table 3-10. Check point for Head Cleaning error (Ink low error) according to each phenomenon
Occurrence
timing Detailed phenomenon
CR position
• Operation
Head Cleaning is not carried out.
• –
Occurrence
timing Detailed phenomenon
CR position
The Digital Camera (as a USB device)
• Operation
cannot be recognized and an error is
• –
indicated.
Occurrence
timing Detailed phenomenon
CR position
• Operation
The Memory Card cannot be recognized
and an error is indicated.
• –
TROUBLESHOOTING
Table 3-9. Check point for Paper out error according to each phenomenon
Defective
unit/part name
1. Check if the tip of the Change Lever is not damaged.
ASF Unit
Defective
unit/part name
1. Check if the ink remains in the Ink Cartridge.
Ink Cartridge
2. Check if the Ink Cartridge can be used by installing it to
Table 3-11. Check point for DSC Direct error according to each phenomenon
Defective
unit/part name
USB Cable 1. Check if the USB Cable is damaged.
2. Confirm whether the digital camera is compatible with
Digital Camera
Table 3-12. Check point for Memory Card error according to each phenomenon
Defective
unit/part name
1. Check if the Memory Card is compatible with the
Memory Card
2. Check if the Memory Card is damaged.
3. Check if a memory card that the adaptor is needed is
1. Check if the Memory Card slot pins on the Main Board
Main Board Unit
Error Indications and Fault Occurrence Causes
Check point
Check point
other printer.
Check point
the printer.
Check point
printer.
inserted into the slot without using the adaptor.
is bent or broken.
Revision A
Remedy
1. Replace the ASF Unit with a new one.
Remedy
1. Replace the Ink Cartridge with a new one.
2. Replace the Ink Cartridge with a new one.
Remedy
1. Replace the USB Cable with a new one.
2. Replace the digital camera with a compatible
one.
Remedy
1. Replace the Memory Card with a compatible
one.
2. Replace the Memory Card with a new one.
3. Turn off the printer, then remove the card
using tweezers or a similar tool.
1. Replace the Main Board Unit with a new one.
Confidential
62