Epson WorkForce 600 Service Manual page 105

Hide thumbs Also See for WorkForce 600:
Table of Contents

Advertisement

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
When removing the Panel Board Frame, do not damage the cable
C A U T I O N
shown in
Figure. 4-33
4.
Remove the screws (x5) securing the Panel Board Frame, and remove the
grounding wire.
5.
Peel off the Panel FFC from the Panel Board Frame and remove the Panel
Board Frame in the direction of the arrow.
Panel Board Frame
Double-sided tape
C.B.P. 3x10, F/Zn-3C (6±1kgfcm)
Positioning hole and dowel
Figure 4-33. Removing the Panel Board Frame
6.
Disconnect the LCD FFC from the connector on the LCD Board.
7.
Disconnect the Panel FFC from the connector on the Panel Board B.
8.
Release the hook (x1) of the Panel Cover and remove the Panel Board and
Panel Board B.
Panel Board B
Hook
Panel Cover
Positioning hole and dowel
Figure 4-34. Removing the Panel Board/ Panel Board B
DISASSEMBLY/ASSEMBLY
with the Panel Board Frame.
Screw it with the grounding wire.
Cable
C A U T I O N
Grounding wire
Panel FFC
Panel Board
LCD Board
LCD FFC
Removing the Circuit Boards
When installing the Panel Board and Panel Board B, make sure
to match the positioning holes (x4) with their positioning pins of
the Panel Cover as shown in
When installing the Panel Board Frame, align the positioning
holes (x2) of the Panel Board Frame with the dowels (x2) of the
Panel Cover as shown in
When installing the Panel Lower Housing, tighten the screws
after aligning the positioning holes (x3) of the Panel Lower
Housing and the hooks (x3) of the Panel Cover as shown in
Figure.
4-32.
4.4.3.2 LCD Module/ LCD Cover
1.
Remove the Panel Board and Panel Board B.
(Refer to
"4.4.3.1 Panel Board/ Panel Board B
2.
Remove the screws (x2) securing the LCD Module and remove the LCD
Module from the Panel Cover.
3.
Peel off the LCD Cover from the Panel Cover.
LCD Module
Panel Cover
Figure 4-35. Removing the LCD Module/ LCD Cover
When installing the LCD Module, be sure to keep out dust between
the LCD Cover and LED Module.
Revision A
Figure.
4-34.
Figure.
4-33.
(p105)")
LCD Cover
C.B.P. 2x6, F/Zn-3C (6±1kgfcm)
Double-sided tape
106
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents