Bi-D Adjustment; Pf Adjustment - Epson WorkForce 600 Service Manual

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW

5.2.4 Bi-D Adjustment

The following pattern is printed for each of the five print mode (five dot size modes).
9 10 11 12
Figure 5-5. Bi-D Adjustment Printout Pattern
How to Judge
Examine the printout patterns for each of the five modes, and enter the value for the
pattern with no gap and overlap for each mode.
Additional Information
If no OK pattern is printed, enter the value for the best one, and print the adjustment
pattern again.
Example for judgement
C H E C K
P O I N T
Overlap
NG
ADJUSTMENT
13 14 15
Gap
OK NG
Using the Adjustment Program (TBD)

5.2.5 PF Adjustment

PF- for standard print area
The following pattern is printed.
Top
Bottom
1 2
Figure 5-6. PF (standard print area) Adjustment Printout Pattern
How to Judge
1. Examine the printed patches from the left to the right, and select a value for
the patch with least white oblique lines on its upper (top) area. If two or more
patches are found as the best patch, be sure to select a value for the left most
one.
Select this
1 2
Figure 5-7. PF Adjustment (1)
2. Examine the printed patches from the right to the left, and select a value for
the patch with least white lines on its lower (bottom) area. If two or more
patches are found as the best patch, be sure to select a value for the right most
one. If it is difficult to judge, compare the most likely patch with the one on
the left.
1 2
Do not select this
Figure 5-8. PF Adjustment (2)
3. Input the selected value for each of the top and bottom in the program, and
print a PF adjustment check pattern.
Revision A
3 4
Do not select this
3 4 5 6
3 4 5 5 6
Select this
Confidential
158