Epson WorkForce 600 Service Manual page 109

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
3. Cut the Cartridge Cover Hinge with a nipper, and remove the upper half of it
and Hinge Cover Cartridge.
4. Release the hooks of the lower half of the Cartridge Cover Hinge with
tweezers, and remove the lower half of it. (See
Cartridge Cover
Hinge Cover Cartridge
Figure 4-44. Removing the Cartridge Cover
5. Release the hook (x1) of the Head Cable Cover with a flathead precision
screwdriver, and remove the Head Cable Cover downward.
6. Release the hook (x1) securing the Ink Guide and remove the Ink Guide.
Hook
Ink Guide
Figure 4-45. Removing the Head Cable Cover
DISASSEMBLY/ASSEMBLY
Figure. 4-43)
Hook
cutting section
Head Cable Cover
Hook
Disassembling the Printer Mechanism
7. Disconnect the Head FFC (x1) that is connected to the CSIC Board.
8. Release the tabs (x2) securing the Holder Board Assy with a flathead
screwdriver or the like, and remove the Holder Board Assy upward.
Tabs
Figure 4-46. Removing the Holder Board Assy
9. Remove the Head Cable Inner Cover according to the following procedure.
9-1. Release the hook (x1) and release the rib (1) of the Head Cable Inner
Cover from the Carriage Unit by lifting upward.
9-2. Remove the Rib (2) of the Head Cable Inner Cover from the Carriage
Unit while sliding it in the direction of the arrow.
Rib (1)
Head Cable Inner Cover
Rib (2)
Figure 4-47. Removing the Head Cable Inner Cover
Revision A
Holder Board Assy
Head FFC Connector
Step 9-1
Hook
Step 9-2
Carriage Unit
Confidential
110