Epson WorkForce 600 Service Manual page 60

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
Occurrence
timing Detailed phenomenon
CR position
• Operation
The drive of the PF Motor is not
transmitted to the LD Roller Shaft.
• –
TROUBLESHOOTING
Table 3-9. Check point for Paper out error according to each phenomenon
Defective
unit/part name
1. Check if the Extension Spring 0.143 does not come off in
the Clutch mechanism.
2. Check if the positioning hole of the Clutch does not come
off from the guide pin of the LD Roller Shaft.
ASF Unit
3. Check if the Clutch tooth is not damaged.
4. Check if the Clutch is not damaged.
5. Check if the Compression Spring 2.36 does not come off
in the Change Lever.
Error Indications and Fault Occurrence Causes
Check point
Extension Spring 0.143
Guide Pin
Clutch
LD Roller Shaft
Change Lever
Compression
Spring 2.36
Revision A
Remedy
1. Reassemble the Extension Spring 0.143 in the
Clutch mechanism.
2. Reassemble the positioning hole of the Clutch
on the guide pin of the LD Roller Shaft.
3. Replace the ASF Unit with a new one.
4. Replace the ASF Unit with a new one.
5. Replace the ASF Unit with a new one.
Confidential
61