Epson WorkForce 600 Service Manual page 100

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
6. Pull out the Panel FFC through the hole of the Panel Lever.
7. Release the dowels (x2) of the Panel Guide Assy, and remove the Panel Guide
Assy from the Panel Unit..
Panel Unit
Panel Lever
Figure 4-18. Removing the Panel Unit (3)
8. Remove the Extension Spring of the Panel Lever that secures the Panel Guide
Assy.
9. Release the hook ( ) of the Panel Lever from the Panel Guide Assy.
10. Slide the Panel Cover in the direction of the arrow to remove it.
11. Release the grounding wire from the Panel Lever.
Panel Lever
Rib and Groove
Hook
Groove
Figure 4-19. Removing the Panel Unit (4)
DISASSEMBLY/ASSEMBLY
Dowels
Panel FFC
hole
Grounding wire
Panel Guide Assy
Extension Spring
Grounding wire
Panel Guide Assy
Removing the Housing
Route the grounding wire through the three grooves of the
Panel Guide Assy and Panel Lever as shown in
Install the Panel Lever, Align the ribs (x2) of the Panel Lever
with the grooves (x2) of the Panel Guide Assy as shown in
Figure. 4-19.
102
Install the Panel Unit to the Upper Housing according to the
following procedure.
1. Align the grooves
the grooves
(Refer to Figure.
Bottom
Figure 4-20. Installing the Panel Unit
2. Insert the Panel Unit to the Upper Housing with the panel
lock pulled toward upside the printer. (Refer to
4-17.)
3. Install the Panel Shafts (x2) into the groove of the Upper
Housing. (Refer to
Route the Panel FFC and grounding wire as shown in
4-17.
Revision A
Figure.
(x2) of the Panel Guide Assy with
(x2) at the bottom of the Upper Housing.
4-20.)
Panel Unit
Panel Guide Assy
Upper Housing
Figure. 4-16.)
Confidential
4-19.
Figure.
Figure.
101