Wireless Lan Module; Disassembling The Panel Unit - Epson WorkForce 600 Service Manual

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW

4.4.2 Wireless LAN Module

Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/ Middle Cover/Printer
Mechanism/Card Slot Cover
Removal procedure
1. Remove the screws (x2) securing the Wireless LAN Module.
Figure 4-30. Removing the Wireless LAN Module (1)
2. Disconnect the Wireless LAN Module cable from the connector on the Main
Board (CN13) and remove the Wireless LAN Module from the MB Front
Shield Plate.
CN13
Figure 4-31. Removing the Wireless LAN Module (2)
DISASSEMBLY/ASSEMBLY
Wireless LAN Module
C.B.S. 3x6, F/Zn-3C (4±0.5kgfcm)
MB Front Shield Plate
Wireless LAN Module
Removing the Circuit Boards

4.4.3 Disassembling the Panel Unit

Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Panel Unit
Removal procedure
4.4.3.1 Panel Board/ Panel Board B
1. Remove the screws (x3) securing the Panel Lower Housing.
2. Remove the hooks (x3) of the Panel Unit and remove the Panel Lower
Housing from the Panel Unit.
3. Pull out the Panel FFC and grounding wire through the hole of the Panel
Lower Housing and remove the Panel Lower Housing from the Panel Unit.
Panel Lower Housing
C.B.P. 3x12, F/Zn-3C (6±1kgfcm)
Positioning hole and Hook
Figure 4-32. Removing the Panel Lower Housing
Revision A
Hole
Grounding wire
Panel FFC
105
Confidential