Waste Ink Pads - Epson WorkForce 600 Service Manual

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW

4.5.20 Waste Ink Pads

Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Printer Mechanism/
Card Slot Cover/Main Board Unit/Left Frame/Front Frame/Right Frame/CR
Motor/CR Scale/Hopper/Main Frame Assy/ASF Unit/Ink System Unit/Star Wheel
Holder Assy/EJ Roller/Front Paper Guide/PF Encoder Sensor/PF Scale/PF Roller
Removal procedure
1. Remove the Waste Ink Pads (x6) from the sections indicated with A to C of
the Base Frame.
A
Figure 4-111. Removing the Waste Ink Pads
DISASSEMBLY/ASSEMBLY
B
C
A: Waste Ink Pads x2
B: Waste Ink Pads x3
C: Waste Ink Pad x1
Disassembling the Printer Mechanism
2. Remove the Waste Ink Cover and the Diffusion Sheet.
Waste Ink Cover
Diffusion Sheet
Figure 4-112. Removing the Waste Ink Cover and Diffusion Sheet
When installing the Diffusion Sheet, Waste Ink Cover, and the
Waste Ink Pads (x3) on section B, attach them in the order
given in the figure below.
3
Figure 4-113. Installing the Waste Ink Pads
When installing the Waste Ink Cover, be sure to align the
dowel (x1) of the Base Frame with the positioning hole (x1) of
the Waste Ink Cover as shown in
confirm the cover is properly secured on the Diffusion Sheet
without any gap.
Whenever the Waste Ink Pads is removed/replaced, the required
A D J U S T M E N T
R E Q U I R E D adjustments must be carried out.
Chapter 5 " ADJUSTMENT" (p.150)
•
Revision A
Dowel and Positioning Hole
1
2
4 5
Figure. 4-112. Make sure to
Confidential
134