Sending A Recorded Message; D Single Tx; D Repeat Tx - Icom IC-7800 Instruction Manual

■ Sending a recorded message

D Single TX

[F-1•T1] [F-2•T2] [F-3•T3] [F-4•T4] [EXIT/SET] [F-7•T/R]
Appears

D Repeat TX

[F-1•T1] [F-2•T2] [F-3•T3] [F-4•T4] [EXIT/SET] [F-7•T/R]
Appears Repeat indicator
✔
For your convenience
When an external keypad or PC keyboard is connected, the recorded message, T1 to T4, can be transmitted
without opening the Voice Recorder screen. See pages 2-6, 2-10 and 12-20 for details.
• The recorded message, T1 to T4 is transmitted once when pushing one of four switches on the external keypad; the re-
corded message is repeatedly transmitted when holding down a switch.
• The recorded message, T1 to T4 is transmitted once when pushing one of [F1] to [F4] key on the PC keyboard; the re-
corded message is repeatedly transmitted when pushing a key while holding down [SHIFT] key.
VOICE RECORDER FUNCTIONS
q Push [EXIT/SET] several times to close a multi-func-
tion screen, if necessary.
w Push [SSB] or [AM/FM] to select a phone mode.
e Push [F-2•VOICE] to enter the Voice Recorder
menu.
r Push [F-1•PLAY] to call up the Voice Recorder screen.
• If the receive voice memory channel appears, push
[F-7•T/R] to select TX memory channel (T1–T4).
t Push a desired memory channel switch, [F-1•T1] to
[F-4•T4], to transmit the recorded voice audio.
• The transceiver transmits automatically.
• "
" indicator appears and the memory timer
counts down.
• You hear the transmitted message from the speaker as
the default setting. This can be turned OFF in voice set
mode. (p. 7-13)
y Push the selected memory channel switch, [F-1•T1]
to [F-4•T4], again to stop, if desired.
• The transceiver returns to receive automatically when all
of the recorded contents in the channel are transmitted.
u Push [EXIT/SET] twice to exit the voice memory screen.
q Perform the steps q to r above.
w Hold down a desired memory channel switch,
[F-1•T1] to [F-4•T4], for 1 second to repeatedly
transmit the recorded voice audio for up to 10 min-
utes at the interval specified in "Repeat Time."
• Even if 10 minutes pass while transmitting, the voice
audio is completely transmitted.
• One of the following steps will cancel the transmission.
- Push the memory again.
- Push another memory (except for [TX LEV.]).
- Exit the TX Voice memory screen.
- Turn OFF the power, then turn it ON again.
- Activate the transmission.
The repeat transmission is cancelled. But while trans-
mitting, the voice audio is completely transmitted.
• Once the Repeat TX is made, the transceiver pauses
until the end of the "Repeat Time," then transmits again.
After the second transmission, the Repeat TX continues
pausing, if receiving a signal. But if the squelch is man-
ually opened, the voice audio is repeatedly transmitted,
according to the repeat time setting.
7-11
7