Canon GP215 Service Manual page 258

3. OPERATIONS AND TIMING
6. Adjusting the AE/Fixing Assembly Settings
Item
AE-SLOP When copying in AE mode with priority on
image quality, some types of originals gen-
erate light images. If such is the case, use
this mode to adjust the copy image density.
FIXER- Use it to enter the resistance of the fixing
RESIST assembly.
• If you have replaced the fixing assembly,
enter the value recorded on the label
attached to the fixing assembly.
0 1 2 3 4
FILM LANK Use it to enter the film thickness rank (fixing
temperature control value).
• If you have replaced the fixing assembly,
enter the value recorded on the label
attached to the fixing assembly, thereby
setting the fixing temperature control
value.
3–204
COPYRIGHT © 1996 CANON INC.
*3* ADJUST 06
AE_SLOP
FIXER-RESIST : xxxxx <– (xxxxx)
FILM-ALNK
ABC_TBL
STRD_ADJ
Description
Resistance
to
XXX
enter
Label
XXX
0 1 2 3 4
Label Value to enter
(in this case,'3')
CANCEL
: xxxxx <– (xxxxx)
: xxxxx <– (xxxxx)
: xxxxx <– (xxxxx)
: xxxxx <– (xxxxx)
+
–
OK
Settings
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
Service handbook
1~19 p.2-21.
Enter a value
higher than the
recorded value by
1 to 2 if shiny
lines (vertical)
occur on solid
black copies.
0~4