Replacing The Rom Dimm; (Image Processor Pcb) - Canon GP215 Service Manual

4. MECHANICAL SYSTEM
2. Removing the LCD PCB and the
CPU PCB
1) Disconnect the connector q, and remove the
six screws w; then, remove the control panel
support e.
3
2
2
Figure 4-803
2) Remove the four screws and three flat cables;
then, remove the LCD PCB r.
3) Remove the two screws, and remove the
switch PCB t; then, remove the four screws
and the two flat cables, and remove the CPU
PCB y.
5 6
Figure 4-804
4–38
COPYRIGHT © 1996 CANON INC.
1
2
2
4
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
C. Replacing the ROM DIMM

(image processor PCB)

1. Removing the ROM DIMM
1) Turn OFF The main power switch.
2) Disconnect the power cord from the power
outlet.
3) Remove the copyboard glass, lens cover, and
IP cover.
4) While opening the claw of the slot, lift the
ROM DIMM to remove.
Figure 4-805