Canon GP215 Service Manual page 223

Type
Paper stopper plate
override
Different number of
originals after jam
removal
Wrong number of origi-
nals
Original forced off
Wrong original size
Wrong original size or
mixed sizes in image
composition mode (See
Note 1.)
Not reset when mode
is changed
Note1:
To reset, remove the originals from the original tray and then open the RDF.
COPYRIGHT © 1996 CANON INC.
Sensor Conditions
S7 The original has ridden over the
paper stopper plate when the origi-
nal was set.
S3 The number of originals on the orig-
inal tray changed as follows:
Number of
originals copied
See Supplement.
S3 The last original cannot be detected
because the re-circulating lever
does not fall through the original
tray.
Reference:
Normally, the original tray holds
50 sheets of A5, STMT, A4, B5,
or LTR, or 25 sheets of A3, B4,
11"x17", or LGL.
S13
The re-circulating lever dropped
through the original tray while an
original was being processed.
S3
The original that has been picked
up is of a non-default size.
S3 q The original is of a size that
image composition mode does
not accommodate.
w The original is of a size different
from the first original.
— q When executing fax mode with-
out resetting after copying mode.
w When making a copy in the
middle of fax operation or when
making a copy without resetting
after fax mode.
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
3. OPERATIONS AND TIMING
Number of originals
>
set on tray
RF operation Code
Stops immediately
upon detection.
Stops immediately
upon detection.
Stops after counting
the 100th original.
Stops immediately
upon detection.
Stops immediately
upon detection.
Stops immediately
upon detection.
See Supplement.
Stops operation im-
mediately upon
detection.
3–169
05H
11H
12H
13H
14H
15H
21H