Canon GP215 Service Manual page 293

When this mode is selected, the sheets set on the RF's original tray will be picked up and stopped on
the copyboard glass. Check how they are stopped, and make adjustments so that they are stopped cor-
rectly.
Making Adjustments
1) Start service mode.
2) Select the appropriate item.
• Press the appropriate item to highlight.
3) Place copy paper on the RF's original tray as follows:
• In the case of 'DOC_ST_T' or 'DOC_ST_B, place one A3 sheet of copy paper.
• In the case of 'P_INTRVL_T' or 'P_INTRVL_B', place two A4 sheets of copy paper.
4) Enter a setting on the keypad.
• In the case of 'DOC_ST_T' or 'DOC_ST_B',
A higher setting will result in a shift to the trailing edge.
A lower setting will result in a shift to the leading edge.
• In the case of 'P_INTRVL_T' or 'P_INTRVL_B',
A higher setting will increase the sheet-to-sheet distance.
A lower setting will decrease the sheet-to-sheet distance.
5) Press the OK key.
• The sheet on the original tray will be picked up and stopped on the copyboard glass.
6) Open the RF slowly, and check where the paper has been stopped.Thereafter, close the RF without
removing the paper. (See below for standards.)
'DOC_ST_T' or 'DOC_ST_B'
1.6±1mm
Copy paper
7) Press the OK key.
• The sheet on the copyboard glass will be discharged to the RF's original tray. (However, in the case
of 'DOC-STP-T' and 'P_INTRVL_T', the sheet will be discharged to the RF's original delivery tray.)
8) To end the work, press the Reset key twice to leave service mode.
COPYRIGHT © 1996 CANON INC. CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
3. OPERATIONS AND TIMING
'P_INTRVL_T' or 'P_INTRVL_B'
Copy paper
0±3mm
Copy paper
3–239