Canon GP215 Service Manual page 400

5. INSTALLATION
3. Installing the Control Card
1) Fix the Control Card q in place on the control
panel using four screws w.
1
2
Figure 5-403
Note 1:
Try sliding in and out a card, and fix the
Control Card V in place where card may be
moved smoothly.
Note 2:
Check to make sure that the connector e for
the printer is centered over the hole.
3
Figure 5-404
5–32
COPYRIGHT © 1996 CANON INC.
2) Install the grounding wire r of the Control
3) Install the control panel to the copier.
4) Install the fixing controller PCB t.
2
6
5) Cut the harness band u shown, and discon-
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
Card V while paying attention to avoid trap-
ping the wires.
At this time, be sure to fix the grounding wire
y of the Control Card V in place by tightening
the screw.
5
Figure 5-405
nect the shorting connector i.
Figure 5-406
7
8