Configuring The Ike Table; Figure 5-52: Ike Table Screen - AudioCodes MediaPack MP-11X User Manual

An example of an IPSec SPD Table is shown below:
[ IPSEC_SPD_TABLE ]
Format SPD_INDEX = IPSecPolicyRemoteIPAddress, IpsecPolicySrcPort,
IPSecPolicyDStPort,IPSecPolicyProtocol, IPSecPolicyLifeInSec,
IPSecPolicyProposalEncryption_0,
IPSecPolicyProposalAuthentication_0,
IPSecPolicyProposalEncryption_1,
IPSecPolicyProposalAuthentication_1,
IPSecPolicyKeyExchangeMethodIndex, IPSecPolicyLocalIPAddressType;
IPSEC_SPD_TABLE 0 = 10.11.2.21, 0, 0, 17, 900, 1,2, 2,2 ,1, 0;
[ \IPSEC_SPD_TABLE ]
In the IPSec SPD example, all packets designated to IP address 10.11.2.21 that originates
from the OAM interface (regardless to their destination and source ports) and whose
protocol is UDP are encrypted, the IPSec SPD also defines an SA lifetime of 900 seconds
and two security proposals: DES/SHA1 and 3DES/SHA1.
5.8.7

Configuring the IKE Table

The 'IKE Table' screen is used to configure the IKE parameters.
To configure the IKE table using the Embedded Web Server, take
these 6 steps:
Access the Embedded Web Server (refer to 'Accessing the Embedded Web Server'
1.
on page 58).
Open the 'IKE Table' screen (Advanced Configuration menu > Security Settings >
2.
IKE Table option).
SIP User's Manual

Figure 5-52: IKE Table Screen

204
MediaPack Series
Document #: LTRT-65409