SIP User's Manual
Warning:
3.1.4.1
Connecting MP-11x to the Network
Follow the procedure below for connecting MP-11x directly to the Ethernet network.
To connect MP-11x directly to the Ethernet network:
Using a crossover Ethernet cable with RJ-45 connectors on either end, connect the
MP-11x Ethernet port (labelled Ethernet), directly to the network. For RJ-45 connector
pinouts, refer to the figure below.
Note:
Version 5.2
To reduce the risk of fire, use only No. 26 AWG or larger
telecommunication line cords.
Figure 3-4: RJ-45 Connector Pinouts
When assigning an IP address to the MP-11x using HTTP (refer to 'Assigning
an IP Address Using HTTP' on page 48), you may be required to disconnect
Ethernet cable and re-cable it differently.
33
3. Installing the MediaPack
August 2007