Figure 5-31: Call Forward Table Screen; Table 5-25: Call Forward Table - AudioCodes MediaPack MP-11X User Manual

To configure the Call Forward table, take these 4 steps:
Open the 'Call Forward Table' screen (Protocol Management menu > Endpoint
1.
Settings submenu > Call Forward option).
Configure the Call Forward parameters for each port according to the table below.
2.
Click the Submit button to save your changes.
3.
To save the changes to flash memory, refer to 'Saving Configuration' on page 238.
4.
Parameter
Forward Type
Forward to Phone
Number
Time for No Reply
Forward
SIP User's Manual

Figure 5-31: Call Forward Table Screen

Table 5-25: Call Forward Table

[0] Deactivate = Don't forward incoming calls (default).
[1] On Busy = Forward incoming calls when the gateway port is busy.
[2] Unconditional = Forward any incoming call to the phone number
specified in the 'Forward to Phone Number' field.
[3] No Answer = Forward incoming calls that are not answered within
the time specified in the 'Time for No Reply Forward' field.
[4] On Busy or No Answer = Forward incoming calls when the port is
busy or when calls are not answered after a configurable period of
time.
[5] Do Not Disturb = Immediately reject incoming calls.
Enter the telephone number or URI (number@IP address) to which the
call is forwarded.
Note: If this field only contains a telephone number and a Proxy isn't
used, the 'forward to' phone number must be specified in the 'Tel to IP
Routing' table of the forwarding gateway.
If you have set the Forward Type for this port to No Answer, enter the
number of seconds the gateway waits before forwarding the call to the
phone number specified.
152
Description
Document #: LTRT-65409
MediaPack Series