AudioCodes MediaPack MP-11X User Manual page 98

Parameter
Hook-Flash Option
[HookFlashOption]
Use INFO for Hook-Flash
[IsHookFlashUsed]
Digit Mapping Rules
[DigitMapping]
Dial Tone Duration [sec]
[TimeForDialTone]
Hotline Dial Tone
Duration
[HotLineToneDuration]
SIP User's Manual
Table 5-11: DTMF and Dialing Parameters
Supported hook-flash Transport Type (method by which hook-flash is sent
and received).
Valid options include:
[0] Not Supported = Hook-Flash indication isn't sent (default)
[1] INFO = Send proprietary INFO message with Hook-Flash indication
[4] RFC 2833
Notes:
FXO gateways support the receiving of RFC 2833 Hook-Flash signals.
The FXS gateways send HookFlash signals only if EnableHold = 0.
This parameter is obsolete; use instead the parameter HookFlashOption.
Digit map pattern. If the digit string (dialed number) has matched one of
the patterns in the digit map, the gateway stops collecting digits and starts
to establish a call with the collected number.
The digit map pattern contains up to 52 options separated by a vertical bar
(|).
The maximum length of the entire digit pattern is limited to 152 characters.
Available notations:
[n-m] represents a range of numbers (not letters)
'.' (single dot) represents repetition
'x' represents any single digit
'T' represents a dial timer (configured by TimeBetweenDigits
parameter)
'S' should be used when a specific rule, that is part of a general rule, is
to be applied immediately. For example, if you enter the general rule
x.T and the specific rule 11x, you should append 'S' to the specific rule
11xS.
For example:
11xS|00T|[1-7]xxx|8xxxxxxx|#xxxxxxx|*xx|91xxxxxxxxxx|9011x.T
Duration (in seconds) that the dial tone is played.
FXS gateway ports play the dial tone after the phone is picked up (off
hook); while FXO gateway ports play the dial tone after port is seized in
response to ringing. The default time is 16 seconds.
Notes:
During play of dial tone, the gateway waits for DTMF digits.
TimeForDialTone is not applicable when Automatic Dialing is enabled.
Duration (in seconds) of the Hotline dial tone.
If no digits are received during the Hotline dial tone duration, the gateway
initiates a call to a preconfigured number (set in the 'Automatic Dialing'
table).
The valid range is 0 to 60. The default time is 16 seconds.
Note: Applicable to FXS and FXO modules.
98
Description
Document #: LTRT-65409
MediaPack Series