AudioCodes MediaPack MP-11X User Manual page 159

SIP User's Manual
Parameter
Disconnect on Dial Tone
[DisconnectOnDialTone
]
Guard Time Between
Calls
[GuardTimeBetweenCal
ls]
Version 5.2
Table 5-27: FXO Parameters
FXO modules can disconnect a call after a dial tone from the PBX is
detected.
[0] Disable = Call isn't released.
[1] Enable = Call is released if dial tone is detected on the gateway's
FXO port (default).
Note: This option is in addition to the mechanism that disconnects a call
when either busy or reorder tones are detected.
Defines the time interval (in seconds) after a call has ended and a new call
can be accepted for IP to Tel calls. This is applicable only to FXO
gateways.
The valid range is 0 to 10. The default value is 1 second.
Note: Occasionally, after a call is ended and onhook is applied, a delay is
required before placing a new call (and performing offhook). This is
necessary to prevent wrong hook-flash detection or other glare
phenomena.
Description
159
5. Web-based Management
August 2007