Figure 5-25: Coder Group Settings Screen - AudioCodes MediaPack MP-11X User Manual

SIP User's Manual
To configure coder groups, take these 11 steps:
Open the 'Coder Group Settings' screen (Protocol Management menu > Profile
1.
Definitions submenu > Coder Group Settings option).
From the 'Coder Group ID' drop-down list, select a coder group ID that you want to
2.
add (up to four coder groups can be configured).
From the 'Coder Name' drop-down list, select the first coder for the coder group. For a
3.
full list of available coders and their corresponding attributes, refer to 'Coders' on page
92.
From the 'Packetization Time' drop-down list, select the packetization time (in msec)
4.
for the coder. The packetization time determines how many coder payloads are
combined into a single RTP packet.
From the 'Rate' drop-down list, select the bit rate (in kbps) for the coder you selected.
5.
In the 'Payload Type' field, if the payload type for the coder you selected is dynamic,
6.
enter a value from 0 to 120 (payload types of 'well-known' coders cannot be modified).
The payload type identifies the format of the RTP payload.
From the 'Silence Suppression' drop-down list, enable or disable the silence
7.
suppression option for the coder you selected.
Repeat steps 3 through 7 for the second to fifth coders (optional).
8.
Repeat steps 2 through 8 for the second to fourth coder groups (optional).
9.
Click the Submit button to save your changes.
10.
To save the changes to flash memory, refer to 'Saving Configuration' on page 238.
11.
Version 5.2

Figure 5-25: Coder Group Settings Screen

139
5. Web-based Management
August 2007