Led Assembly Removal - Lexmark X925 Service Manual

LED assembly removal

1.
Remove the transfer belt. See
2.
Remove the top cover. See
3.
Remove the rear EMI shield. See
4.
Remove the toner cartridges and imaging units.
5.
Disconnect the affected LED's ribbon cable from the printhead controller board.
6.
Guide the printhead ribbon cable through the top of the print engine.
7.
Remove the head holder screw (A) securing the LED holder to the top frame.
Note: You will need to remove the top EMI shield to access the screw if you are removing the magenta or
yellow LED assembly. See
"Transfer belt – CRU" on page
"Output bin (print engine top) cover" on page
"Rear EMI shield – Not a FRU" on page
"Top EMI sheild removal" on page
4-40.
4-17.
4-106.
4-39.
Repair information
7541-03x
4-29