Lexmark X925 Service Manual page 108

7541-03x
Error code
56 USB Port <x>
Disabled
56 Standard USB Port
Disabled
57 Configuration
Change
Held Jobs May Not
Be Restored
See Configuration
Change, above - not in
IR as 57
58 Too Many Flash
Options
58 Too Many Trays
Attached
61 Defective Disk
62 Disk full
63 Unformatted disk
64 Unsupported disk
format
2-72
Service Manual
Action
• Select Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the PCI card.
• Select Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the RIP board. See
page 4-73.
Configuration changes may be:
• Code version changes
• Paper handling options removed
• The disk was installed from a different model or speed of printer.
Too many flash options are installed. To continue:
1. Turn off and unplug the printer.
2. Remove the excess flash memory.
3. Plug in the printer, and turn it on.
If this does not fix the problem, replace the If this does not fix the problem, replace the RIP
board. See "RIP board removal" on page
1. Turn off and unplug the printer.
2. Remove options until the supported number of options for that model. Models C925
supports three additional trays.
3. Plug in the printer, and turn it on.
• Select Continue to clear the message and continue printing.
• Install a different hard disk before performing any operations that require a hard disk.
• If this does not fix the problem, replace the RIP board. See
page 4-73.
• Select Continue to clear the message and continue processing.
• Any information not previously stored on the hard disk is deleted.
• Delete fonts, macros, and other data stored on the hard disk.
• Install a larger hard disk.
• If this does not fix the problem, replace the RIP board. See
page 4-73.
• Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the RIP board. See
page 4-73.
• Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the RIP board. See
page 4-73.
"RIP board removal" on
4-73.
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on