Lexmark X925 Service Manual page 79

Fax error log codes (Continued)
Error code Description
882 Failure to transmit training successfully
in V17, V29 terminal modulation
schemes.
883 Failure to transmit training successfully
in V17,V27 terminal modulation
schemes.
884 Failure to transmit training successfully
in V29, V27 terminal modulation
schemes.
885 Failure to transmit training successfully
in V17terminal modulation scheme.
886 Failure to transmit training successfully
in V29 terminal modulation scheme.
887 Failure to transmit training successfully
in V27 terminal modulation scheme.
888 Failure to transmit training successfully
at 2400 bps in V27 terminal modulation
scheme.
889 Failed to connect at the minimum
speed supported by the MFP.
88A Failed to connect using V.34
modulation scheme.
901 No fax tones detected from remote
end.
902 No dial tone detected.
903 Busy tone detected.
904 Hardware error detected.
905 A timeout occurred after dialing the
number and waiting for a response.
906 Fax cancelled by user.
Action
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Adjust "Transmit Level".
• Check line quality.
• Adjust "Transmit Level".
• Incompatible connection.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
• Check by enabling 'Behind a PABX'
setting.
• Check phone line.
• Check MFD modem hardware.
Check with remote end if successive
attempts fail.
See "No dial tone" on page
Check with remote end if successive
attempts fail.
No action needed.
Diagnostic information
7541-03x
2-83.
2-43