Reset Transfer Belt Counter
This menu item is used to reset the fuser counter for the print engine.
1.
Touch the menu item. A "Reset Fuser Counter" button is displayed.
2.
Touch that button to reset the counter.
USB Scan to Local
When set to Off, this setting tells the USB device driver to enumerate as a USB Simple device. When this is set
to on, USB device driver enumerates as a USB Composite device (multiple interfaces).
Black Only Mode
When this setting is set to On the printer prints only grayscale printing. The default is Off. The result is similar to
setting Print Mode to Black Only.
Note: This setting appears only when the PJL Password Environment variable is set to 0.
Print Quality Pages
The Print Quality Test consists of five pages. Pages one and two contain a mixture of graphics and text. The
remainder of the pages only contain graphics. Use this test to identify print quality problems. The Test Pages
must be printed on A4, Legal, or Letter paper.
Fuser Speed
Use this setting if the device is encountering a shock line issue. After adjusting the setting, the device will print
the Print Quality Pages. It is recommended that this menu setting is used under the guidance of your second
level of support.
Reports
From this menu you can print the Menu Settings Page or the Event Log. (Will event log be added?)
Color Trapping
Color trapping is an aid to graphics and text. When text or graphics appear over other colors, a misalignment
may allow white paper to show through at the borders of the colors. Color trapping increases the amount of color
under the upper image so a slight misalignment does not show. This affects PCL 5e, PCL XL, PDF, and
PostScript printing.
Increasing the value increases the amount of color remaining beneath the black content, in increments of 1/600
of an inch.
1.
Select Color Trapping from the Configuration menu.
2.
Select the value or Off. The range is 1 to 5, and the default value is 2.
Press (+) to increase the value.
3.
Press Check to accept.
7541-03x
3-11
Diagnostic aids