Paper Feed Unit Removal - Lexmark X925 Service Manual

7541-03x

Paper feed unit removal

1.
Remove the HVPS. See
2.
Remove the complete duplex unit. See
3.
Using a flatblade screwdriver, gently push the tab securing the link arm to the link arm stay back, and
remove the right link arm.
Note: Use care when pushing the tab back. It can easily break if pushed too far.
4.
Disconnect the registration clutch harness from connector CN20 on the printhead controller board.
5.
Disconnect the pick roll, separator roll, and feed roll clutch cables from connector CN8 on the MDCONT
(engine) board.
6.
Disconnect the paperfeed unit sensors cable from CN12 on the engine board.
7.
Disconnect the paper feed unit motor harness from connect or CN16 on the MDCONT (Engine) board.
4-68
Service Manual
"HVPS removal" on page
"Duplex removal" on page
4-111.
4-63.