7541-03x
Registration sensor actuator removal
Note: The paperfeed unit does not need to be removed from the printer.
1.
Open the right cover door.
2.
Pull the cassette guide down.
3.
Place a flatbed screwdriver under the right side of the actuator, using it as a lever to pull the actuator shaft
out of the cassette guide.
Static discharge brush removal
1.
Remove the paperfeed unit. See
2.
Remove the six screws (A) that secure the discharge brush plate to the paperfeed unit.
4-180
Service Manual
"Power supply fan removal" on page
4-55.