Table of Contents
Advertisement
20. Attach the tethered end cap from the fiber optic bundle to the threaded hole on the base of the
projector.
21. Replace the breakout ferrule on the fiber optic strain relief with the four screws removed in step
7.
22. Replace the cover of the fiber optic strain relief with the four screws removed in step 3.
23. Close and lock the Optical Access door.
Connect the interlock to the projector
1. Attach the female connector of the longest 9-pin Interlock cable to the Interlock IN connector
of the bottom laser module in the laser rack.
See
Connect the interlock cables to the laser modules
2. Connect the male connector of the cable to the Laser Interlock connector at the back of the
projector.
Connect the laser rack harness
1. Connect the 25-pin laser rack harness to the laser rack connector at the back of the projector.
Connect the Ethernet cable to the projector
1. Remove the bottom cover of the touch pad controller.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
on page 32.
Installation
41
Advertisement
Table of Contents
