Table of Contents
Advertisement
12. If it is dirty, blow the surface with a stream of clean dry air (CDA) to dislodge larger, loose,
particles.
13. Re-inspect the fiber optic cable.
14. If the fiber end face still appears contaminated, apply some isopropyl alcohol to the tip of a
cotton swab and gently wipe the surface.
15. Inspect the fiber optic cable again.
16. If it is still dirty, repeat steps 12 to 15 until the end face is clean.
17. Open the dust cover on the fiber receiver.
18. Insert the cable with the dowel pin and dowel hole lined up. Insert the cable all the way in until
it stops.
19. Finger-tighten the coupler to secure the fiber optic connection.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Installation
40
Advertisement
Table of Contents
