Table of Contents
Advertisement
Turn on all laser modules
The remaining image adjustments require power on all laser modules.
1. In the Laser Bank Control Application under Available Modules, click Connect All.
2. Under System > Power Status, click Standby.
The laser module tabs read WARMUP.
3. When the laser module tabs read STANDBY, click On.
4. In the System Power group, bring Green to 100 %.
Adjust horizontal boresight
Failure to comply with the following could result in death or serious injury.
• Do not look into the lens. The extreme brightness will cause permanent eye damage.
• Keep hands, clothing, and all combustible material away from the light path.
Adjust the Boresight with low light levels from a single laser module. Failure to comply could
result in minor or moderate injury.
Adjust the boresight if the image cannot be focused uniformly across the screen.
1. Loosen the horizontal lock screw (A).
2. Extend the lens focus completely.
Using the focus knob to retract the lens, adjust the Focus. Watch the image at the left edge of
the screen until it comes into focus.
3. If the entire screen is in focus, proceed to step 8.
4. Continue retracting the lens.
a. If the right side of the image comes into focus before the lens is completely retracted,
adjust the horizontal boresight bolt (B) to balance the left and right edges.
b. If the right side of the image fails to focus, adjust the horizontal boresight bolt (B).
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
A
B
Adjust the Image
C
58
Advertisement
Table of Contents
